Fixed problem that caused freshly-formatted SD cards to cause Error Code 3 and Error Code 7.
Made some speed improvements in USB download.
Should use with iP3USBLib v1.0.21 and above for maximum effect.
Added load-leveling code to reduce excessive SD card writes.
Fixed bug that caused long shows to eventually slow down.
Extended DMX "Break" duration to match spec.
Fixed menu bug that occurred whenever a user chose "No" at the "Save Changes" prompt inside the "Triggers" submenu.
Fixed subtle bug in "Set Relative Brightness" expansion port command implementation.
Fixed DMX bug that caused occasional empty frames (with only Break, then Mark, then Start Code, but no data) to be generated).
Added ability to send arbitrary DMX frames via USB in order to facilitate creation of tools like SAS and PDSTool for iPlayer3.
Fixed bug that required a power cycle (due to Alarm Error) after powering up an iPlayer3 with a freshly-formatted SD card in it.
Fixed the "Error Code 3" file corruption bug caused by excessive SD card sector wear.
Fixed onboard user interface bug that capped "seconds" fields at a value of 58.
Fixed problem with expansion port command response strings.
Fixed bug that prevented users from clearing an alarm from the onboard UI.