Release Notes - iPlayer3: v1.0.52

• Fix bug in cross-fade transitions between two downloaded shows.

Release Notes - iPlayer3: v1.0.51

• Increase number of alarms from 16 to 64. A newer version of ColorPlay is required to take advantage of this feature.

Release Notes - iPlayer3: v1.0.50

• Fix bug that shifted most DMX values down by 1.
• Change up/down button response so each click corresponds to 1 count in the 0-100 range.

Release Notes - iPlayer3: v1.0.49

• Fix bug that prevented entering effect times greater than about 13 minutes.

Release Notes - iPlayer3: v1.0.48

• Correct sunrise / sunset calculations:
• Fix lat/long UI so you can enter a value between 0.0 and -1.0.
• Fix interpretation of int and frac components of lat/long.
• Change astronomical zenith to correct value.

Release Notes - iPlayer3: v1.0.47

• Fixed bug that caused 513 bytes to be output after start code instead of 512, which caused incompatibility with Pathways Connectivity devices.

Release Notes - iPlayer3: v1.0.46

• Add Button Sensitivity setting to setup menu, range 0 - 5.
• 0 is most sensitive (original behavior). 1 is the new manufacturing default.
• Higher numbers are more noise immune, but have noticible "lag."

Release Notes - iPlayer3: v1.0.45

• Fix intermittent error in audio output ISR.

Release Notes - iPlayer3: v1.0.44

• Fix clock startup problems with new versions of silicon.
• Improve SD card write speed.
• Improve power-up speed.

Release Notes - iPlayer3: v1.0.43

1559: v1.0.42 flicker fix broke show to show cross fade

Fixed a bug in v1.0.42 that made show-to-show cross fade stop working.

Release Notes - iPlayer3: v1.0.42

1556: Add "Next Alarm" feature to UI

Added Info->View Alarms menu item to user interface.

1549: Alarms based on astro clock are broken with negative minutes

Fixed several issues related to Alarms based on Astronomical Clock values.

1555: iP3/Keypad Flicker w/ Dimming

Fixed a bug that causes a brief flicker at the end of a downloaded show set to loop, when the iP3 brightness is less than 100%.

Release Notes - iPlayer3: v1.0.41

1441: Alarms set on specific day don't work

Fixed bug in day-of-week calculation that caused alarms configured to fire on a particular day of the week to fire on the wrong day.

Release Notes - iPlayer3: v1.0.40

1422: Error Code 7 Reoccurrence

Fixed problem that caused freshly-formatted SD cards to cause Error Code 3 and Error Code 7.

Release Notes - iPlayer3: v1.0.39

1401: USB file write is painfully slow

Made some speed improvements in USB download.
Should use with iP3USBLib v1.0.21 and above for maximum effect.

Release Notes - iPlayer3: v1.0.38

1295: Load-level SD card writes

Added load-leveling code to reduce excessive SD card writes.

1395: Playback of large files slows down over time

Fixed bug that caused long shows to eventually slow down.

Release Notes - iPlayer3: v1.0.37

1357: Break timing off

Extended DMX "Break" duration to match spec.

Release Notes - iPlayer3: v1.0.36

1316: Save changes on Triggers submenu has yes/no mapped wrong

Fixed menu bug that occurred whenever a user chose "No" at the "Save Changes" prompt inside the "Triggers" submenu.

1303: Relative Intensity Decrease via RS232

Fixed subtle bug in "Set Relative Brightness" expansion port command implementation.

Release Notes - iPlayer3: v1.0.35

1313: Empty DMX Frame

Fixed DMX bug that caused occasional empty frames (with only Break, then Mark, then Start Code, but no data) to be generated).

Release Notes - iPlayer3: v1.0.34

1311: Add DMX frame USB command

Added ability to send arbitrary DMX frames via USB in order to facilitate creation of tools like SAS and PDSTool for iPlayer3.

Release Notes - iPlayer3: v1.0.33

1294: Alarm error thrown on blank SD card

Fixed bug that required a power cycle (due to Alarm Error) after powering up an iPlayer3 with a freshly-formatted SD card in it.

1293: SD card corruption

Fixed the "Error Code 3" file corruption bug caused by excessive SD card sector wear.

1291: Seconds capped at 58 in iPlayer3 UI

Fixed onboard user interface bug that capped "seconds" fields at a value of 58.

Release Notes - iPlayer3: v1.0.32

1274: SERIAL TRIGGERING

Fixed problem with expansion port command response strings.

1248: Can't clear alarm from UI?

Fixed bug that prevented users from clearing an alarm from the onboard UI.